TABLES TEMPLATE
LAYOUTS
MODELERS IN ACTION
WIRING
We use a simple wire Block at the end of each table to parallel above table track. Wires soldered to tracks are inserted below the table via a small drilled hole in the Foam board and thin plywood. The track wires are joined at the blocks, along with wires that run as a "harness" from table to table.
To connect a wire harness from table to table we use simple trailer hitch plugs to join electrical power down the line.
Everett Stoub has also introduced a wiring concept we had only considered. Everett will poke his wires in from the top, then flip the module upside down, Kam Lock the module in place, then comfortably wire the table from the Top Side.
To connect a wire harness from table to table we use simple trailer hitch plugs to join electrical power down the line.
Everett Stoub has also introduced a wiring concept we had only considered. Everett will poke his wires in from the top, then flip the module upside down, Kam Lock the module in place, then comfortably wire the table from the Top Side.